CLQTS - FORMULA 150 PRIMER (MIL P 24441) CONVERTER 5748
- MSDS: CLQTS
- Manufacturer: INTERNATIONAL PAINT INC
- Product Name: FORMULA 150 PRIMER (MIL P 24441) CONVERTER 5748
- National Stock Number: 8010-01-302-3607
Product Identification
Product ID:FORMULA 150 PRIMER (MIL P 24441) CONVERTER 5748
MSDS Date:04/20/1999
FSC:8010
NIIN:01-302-3607
Status Code:A
MSDS Number: CLQTS
Responsible Party
HOUSTON, TX 77091
US
Emergency Phone: 800-854-6813
Info Phone: 713-684-1244
Preparer: ERNEST CARTER
Cage: 028S6
Contractor
Telephone: 713-684-1244
Cage: 028S6
Ingredients
EPOXY RESIN
CAS: 25068-38-6
RTECS: CE6880000
AROMATIC HYDROCARBONS
CAS: 64742-95-6
RTECS: WF3400000
TRIMETHYLBENZENE
CAS: 25551-13-7
RTECS: DC3220000
ACGIH TLV: 123 MG/M3;25 PPM
MAGNESIUM SILICATE HYDRATE
CAS: 14807-96-6
RTECS: WW2710000
OSHA PEL see Table Z-3
ACGIH TLV: 2 MG/M3
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: CAUSES NOSE AND THROAT
IRRITATION. VAPOR HARMFUL. MAY AFFECT THE BRAIN OR NERVOUS SYSTEM
CAUSING DIZZINESS, HEADACHE OR NAUSEA. EYE CONTACT: CAUSES EYE
IRRITATION. SKIN CONTACT: CAUSES SKI N IRRITATION. MAY CAUSE
ALLERGIC SKIN REACTION OR SKIN SENSITIZATION. INGESTION: HARMFUL IF
SWALLOWED.
Explanation of Carcinogenicity:CONTAINS AN INGREDIENT LISTED AS KNOWN
OR SUSPECTED CARCINOGEN?
Medical Cond Aggravated by Exposure:
First Aid
First Aid:INHALATION: REMOVE TO FRESH AIR, IF DISCOMFORT IS PRESENT OR
BREATHING IS ABSENT GET MEDICAL ATTENTION IMMEDIATELY. EYE CONTACT:
FLUSH IMMEDIATELY WITH PLENTY OF WATER FOR 15 MINUTES UNTIL
IRRITATION SUBSIDES. IF IRRITATION PERSISTS, GET MEDICAL
ATTENTION. SKIN CONTACT: FLUSH WITH LARGE AMOUNTS OF WATER. USE
SOAP IF AVAILABLE. REMOVE SEVERELY CONTAMINATED CLOTHING.
INGESTION: IF SWALLOWED, DO NOT INDUCE VOMITING. KEEP AT REST. GET
PROMPT MEDICAL ATTENTION.
Fire Fighting
Flash Point:=46.1C, 115.F
Lower Limits:1%
Extinguishing Media:FOAM, CARBON DIOXIDE, DRY CHEMICAL
Unusual Fire/Explosion Hazard:ISOLATE FROM HEAT, SPARKS, ELECTRICAL
EQUIPMENT AND OPEN FLAME. CLOSED CONTAINERS MAY EXPLODE WHEN
EXPOSED TO EXTREME HEAT. IN THE ABSENCE OF ELECTRICITY, A WATER
SPRAY (A FOG NOZZLE IS PREFERRED) MAY BE USED TO COOL CONTAINERS.
DECOMPOSITION AND COMBUSTION PRODUCTS MAY BE TOXIC.
Accidental Release
Spill Release Procedures:CONTAIN SPILLED LIQUID WITH SAND OR EARTH. DO
NOT USE COMBUSTIBLE MATERIALS SUCH AS SAWDUST, ABSORB SPILL WITH AN
INERT MATERIAL (E,G. DRY SAND OR EARTH), THEN PLACE IN A CHEMICAL
WASTE CONTAINER.
Handling
Handling and Storage Precautions:KEEP CONTAINER CLOSED. LOOSEN CLOSURE
CAUTIOUSLY BEFORE OPENING. STORE IN A COOL, WELL VENTILATED PLACE
AWAY FROM INCOMPATIBLE MATERIALS. (SEE STABILITY AND REACTIVITY
SECTION 10.) KEEP AWAY FROM HEAT , SPARKS AND FLAMES. PROTECT
MATERIAL FROM DIRECT SUNLIGHT, GROUND AND BOND CONTAINERS.
Exposure Controls
Respiratory Protection:DO NOT BREATHE VAPORS OR SPRAY MIST.IF YOU
EXPERIENCE EYE WATERING, HEADACHE OR DIZZINESS OR IF AIR MONITORING
DEMONSTRATES VAPOR/MIST LEVELS ARE ABOVE APPLICABLE LIMITS, WEAR AN
APPROPRIATE, PROPERLY FITTED RESPIRATOR (NIOSH APPROVED) DURING
AND AFTER APPLICATION. FOLLOW RESPIRATOR MANUFACTURE'S DIRECTIONS
FOR RESPIRATOR USE.
Ventilation:PROVIDE SUFFICIENT VENTILATION, IN VOLUME AND PATTERN,
TO:A) KEEP THE TLV OF THE HAZARDOUS INGREDIENTS BELOW THE LIMITS.
Protective Gloves:WEAR CHEMICAL RESISTANT GLOVES.
Eye Protection:SAFETY GLASSES, CHEMICAL GOGGLES AND/OR A FACE SHIELD.
Other Protective Equipment:AS NEEDED, USE BODY PROTECTION TO AVOID
CONTACT WITH PRODUCT.
Supplemental Safety and Health
Chemical Properties
Boiling Pt:=148.9C, 300.F
Vapor Density:HEAVIER
Spec Gravity:1.208
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:LIQUID
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:STRONG OXIDIZING AGENTS
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED TO DECOMPOSITION AS IN WELDING. FUMES MAY PRODUCE CARBON
DIOXIDE AND CARBON MONOXIDE.
Conditions to Avoid Polymerization:WILL NOT OCCUR.
Disposal
Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS. DO NOT INCINERATE UNOPENED CONTAINERS.
Toxicology
Toxicological Information:THERE IS NO DATA AVAILABLE ON THE PRODUCT
ITSELF. NOTICE: REPORTS HAVE ASSOCIATED REPEATED AND PROLONGED
OCCUPATIONAL OVEREXPOSURE TO SOLVENTS WITH PERMANENT BRAIN AND
NERVOUS SYSTEM DAMAGE. INTENTION AL MISUSE BY DELIBERATELY
CONCENTRATING AND INHALING THE CONTENTS MAY BE HARMFUL OR FATAL.
Other Information
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
Regulatory
SARA Title III Information:(SUPERFUND AMENDMENTS AND REAUTHORIZATION
ACT): NONE KNOWN UNLESS CHEMICALS ARE SPECIFIED BELOW. SECTION 302
REPORTABLE INGREDIENTS 313 REPORTABLE INGREDIENTS.
Federal Regulatory Information:TSCA (TOXIC SUBSTANCE CONTROL ACT):
COMPONENTS OF THIS PRODUCT ARE LISTED ON THE TSCA INVENTORY.
CERCLA (COMPREHENSIVE RESPONSE COMPENSATION, AND LIABILITY ACT): WE
RECOMMEND YOU CONTACT LOCAL AUTHO RITIES TO DETERMINE IF THERE MAY
BE OTHER LOCAL REPORTING REQUIREMENTS.
State Regulatory Information:CALIFORNIA PROPOSITION 65: NONE KNOWN
UNLESS SPECIFIED BELOW WARNING: THIS PRODUCT CONTAINS A CHEMICAL
KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER.